IHMC CmapTools & CmapServer Support Forum

5.03 WIN XP

When I start cmap tools the cmap views pops up and states that it is loading but it remains stuck in the loading mode and I cannot operate cmap tools. This occurred after I switched preferences to save to my thumb drive. I then uninstalled then re-installed cmap and this did not change the problem. It remains hung on 'loading'. Any thoughts on this problem?

I had a similar problem... It is expecting to see your thumbdrive. Insert it before starting up Cmaptools should cure the problem (you can then change the 'home' drive to your hard disk using the preferences menu if you want to).

Regards,

Phil